Onyx Maintenance
Verfasst: 20.09.2006 16:35
CLICK ON PICTURES TO ENLARGE!
Bolt:
Get out your purdy Onyx
Unscrew the screw on the back plate
Push the bolt assembly out the back and wipe off all old lube
Remove back plate by removing the three small set screws, and then pulling directly backwards
Unscrew the two sections of the valve chamber
Unscrew your bolt (if you cannot get it off by hand, you can use a nut driver on the back of the ram [where you just took off the back plate] to get a grip on it)
Slide the front half of the valve chamber off the front
Remove the poppit and spring
Push the ram out the back
Now you have everything apart
Wipe off old lube and lube the poppit with Dow55 as shown
Place the sping back in the chamber in its spot, as shown
Put the poppit ontop of it
Wipe off old lube and lube the back part of the valve chamger with Dow55 as shown
Screw the two halves of the valve chamger together
Wipe off old lube and lube the ram with Dow55 as shown