eigene Beiträge| neueste Beiträge| ungelesene Beiträge| unbeantwortete Beiträge| aktive Themen| Fördermitgliedschaft| Cockerpage

Onyx Maintenance

Insight, Victory, G6R, Intimidator, Marq, Vice, Protege
Bild

Benutzeravatar
Florian
Der alte Mann und das Hub
Wohnort: Frankfurt am Meer
ForumBadges: Bild
Beiträge: 25876
Registriert: 23.09.2003 12:25

Onyx Maintenance

#1

20.09.2006 16:35

CLICK ON PICTURES TO ENLARGE!

Bolt:

Get out your purdy Onyx ;)
Bild

Unscrew the screw on the back plate
Bild

Push the bolt assembly out the back and wipe off all old lube
Bild
Bild

Remove back plate by removing the three small set screws, and then pulling directly backwards
Bild

Unscrew the two sections of the valve chamber
Bild

Unscrew your bolt (if you cannot get it off by hand, you can use a nut driver on the back of the ram [where you just took off the back plate] to get a grip on it)
Bild

Slide the front half of the valve chamber off the front
Bild

Remove the poppit and spring
Bild

Push the ram out the back
Bild

Now you have everything apart :)
Bild

Wipe off old lube and lube the poppit with Dow55 as shown
Bild

Place the sping back in the chamber in its spot, as shown
Bild

Put the poppit ontop of it
Bild

Wipe off old lube and lube the back part of the valve chamger with Dow55 as shown
Bild

Screw the two halves of the valve chamger together
Bild

Wipe off old lube and lube the ram with Dow55 as shown
Bild

Link:
BBcode:
HTML:
Hide post links
Show post links
Benutzeravatar
Florian
Der alte Mann und das Hub
Wohnort: Frankfurt am Meer
ForumBadges: Bild
Beiträge: 25876
Registriert: 23.09.2003 12:25

#2

20.09.2006 16:36

Place the ram through the back
Bild

Screw the bolt back on the ram. Use a 1/4" nut driver on the back of the ram to get it on nice and tight, you do NOT want it coming loose or coming off during firing
Bild

Re-attach the back plate so the bottom part of the plate with the spot for the screw aligns with the air hole in the back part near the ram as shown and replace the three small set screws
Bild

Wipe off old lube and lube all except the bolt with Dow55, use Dow33 on the bolt, as 55 on it can cause some drop off. Dow33 = bolt; Dow55 = everything else.
Bild

Put it back in the gun and screw it back on, and you're good to go. :D

HPR-

Take th HPR off the gun
Bild

Unscrew the two halves
Bild

Take out the adjustment screw
Bild
Bild

Push out the internals
Bild

Wipe off all lube and relube with Dow55 and reassmble, simple as that. :)
Bild


Will do the LPR once I make my pressure gauge for the LPR so I know what to set it at once I'm done...

Link:
BBcode:
HTML:
Hide post links
Show post links

Zurück zu „Bob Long“

Wer ist online?

Mitglieder in diesem Forum: 0 Mitglieder und 1 Gast