Hallo hab ne frage bezüglich des 3 Fach verstellbaren triggers der extcy.
Wo kann man denn den 3 Punkt einstellen ich kenne nur die madensxhraube direkt am trigger und die von unten am griff. Vielleicht könnt ihr mir ja helfen.
Extcy trigger einstellen
- Frankb
- Will hier nur verkaufen
- icp-ms
- Rain Man
- ForumBadges:
- XtraBadges: zeigen
Beitrag
Du kannst nur Pre und Post Travel einstellen
Den Firing Point kannst nicht einstellen
Das mit dem dreifach einstellbar ist sicher ein Copy/ Paste Fehler
Den Firing Point kannst nicht einstellen
Das mit dem dreifach einstellbar ist sicher ein Copy/ Paste Fehler
The length of the eXTCyTM trigger pull is fully adjustable.
A setscrew in the lower half of the trigger sets the post-travel adjustment, or how far back the trigger
can be pulled. Turning the screw clockwise with a 0.05-inch allen wrench will shorten the trigger
pull. Turning counter-clockwise will increase it. When setting post-travel limit, it is important that the
trigger pull is not set so short that the trigger does not activate the microswitch on the eXTCyTM’s
circuit board, as this would leave the marker unable to fire. Similarly, the post-travel adjustment screw
must butt up against the trigger frame when the trigger is pulled. If the post-travel screw is underadjusted
the trigger will stop against the microswitch inside the marker, instead of on the screw. This
situation can cause damage to the microswitch and or circuit board when the trigger is pulled hard.
The forward limit of the trigger’s movement, or pre-travel is adjusted by the use of a 1/8-inch allen
wrench. The pre-travel trigger adjustment screw is located at the bottom of the trigger guard where it
meets the grip frame. It may be helpful to remove the marker’s rubber grips to provide easier access
when making adjustments. As when changing the battery, it is better to completely remove the rubber
grip than to only open one side and fold it past the trigger guard. Turning the pre-travel adjustment
screw clockwise decreases how far forward the trigger can move, while turning counterclockwise
increases. If the trigger is not adjusted to swing far enough forward when released, the microswitch
inside the eXTCyTM will not be able to reset, resulting in the marker not firing.
Always check the trigger after making adjustments. Be sure that the trigger switch clicks when the
trigger is pulled, and again when it is released. Also make sure that when the trigger is pulled it is
being stopped by the post-travel adjustment screw, not by pressing up against the microswitch
inside the marker.
- Dateianhänge
-
- extcy Trigger.png (39.93 KiB) 1861 mal betrachtet
Link: | |
BBcode: | |
HTML: | |
Hide post links |
Wer ist online?
Mitglieder in diesem Forum: 0 Mitglieder und 5 Gäste