- 6 meters of PVC pipe (3cm wide)
- 3 "T" pvc connectors
- 8 90degree connectors
- 1 male pvc (has threads)
- 1 female pvc
Cut the 6 meters of pipe into:
- se 4 x 5.5cm
- se 3 x 5cm
- se 2 x 6.25cm
- se 2 x 45cm
- se 1 x 24cm (if u have no drop then make this shorter)
reference pic
1. Put 90degree connectors on the two 45cm pipes
2. Insert the 5.5cm pipes to the connectors
3. Place two T connectors as shown
4. Insert one 5cm piece as shown
5. Add a T connector as shown
6. Place the 6.25cm as shown
7. Connect two 90 degree connectors
8. Add the last two 5cm pipes
9. Place the two last 90 degree connectors as shown (this is where your gun's tank will be placed) you may tilt it a bit
10. Add the 24cm pipe make it shorter if u have no drop
11. Place male connector
12. Place female connector, this is where your barrel will go
13. Ready! you can paint it as you wish
p.s. patent from a friend
